Lotus stems and biofilms generate electricity from evaporating water to power small electronics

Spread the love
Researchers use lotus stems and bacterial films to generate electricity for small devices
Graphical abstract. Credit: Device (2026). DOI: 10.1016/j.device.2026.101340

Researchers in China have developed a hydrovoltaic generator that takes advantage of the vertical channels in lotus stems, along with a bacterial biofilm that enhances ionic conductivity and charge transport. The new study, published in the journal Device, reports that the devices were capable of powering small electronics like pocket calculators and lights and achieved a stable output for over 30 days.

Water-evaporation-induced electricity generation
Water evaporation–driven generators, or WEGs, harvest environmental heat as water evaporates, producing small amounts of power. However, many WEGs use materials like carbon nanotubes or nanofiber polymers that contain tangled pore networks. This hinders the movement and collection of electrical charge, resulting in a less efficient device.

Some approaches improved performance through engineered surfaces and structures, but often required complex processing. Still, if optimized, WEG technology offers a simpler, more sustainable way to supply power to remote sensors or other low-power electronics in places where replacing conventional batteries is difficult.

WEG gets a lotus/bacteria upgrade
The team involved in the new study developed a design for a WEG, combining straight stem channels in the lotus plant with conductive bacterial films. Lotus stems contain naturally aligned channels that offer ready-made pathways for water transport. Previous work also showed that Geobacter sulfurreducens biofilms can generate electricity during water evaporation. The combination creates a pathway allowing for efficient directional ion transport and charge conduction.

To create a working WEG, the researchers soaked lotus-stem segments in a bacterial suspension, freeze-dried them and attached electrodes at both ends. They then analyzed electrical output, examined the internal channels and tested environmental conditions and different electrode materials to optimize the device.

The study authors write, “The vertically aligned porous architecture of lotus stems reduces hydraulic resistance and optimizes water molecule transport pathways. This structure provides more direct flow paths while suppressing outward scattering of water molecules. Simultaneously, this architecture enables liquid motion under reduced viscous resistance, generating efficient and rapid charge transport. The porous directional structure also minimizes turbulence generation, enhancing water transport and ionic diffusion, consequently promoting power generation performance.”

They found that bacterial-film-coated lotus stems produced more electricity than untreated stems, with lower internal electrical resistance. The optimized lotus stem/G. sulfurreducens (LSG) WEG produced a steady-state power density of 63 microwatts per square centimeter and reached an open-circuit voltage of 1.48 volts. The devices maintained electrical output over 30 days. Although long-term output was below the optimized values, the study authors say the decay was less than 15%.

Connecting the devices allowed for enough power to operate small devices. A calculator was powered by three series-connected units, and a small lamp or electronic ink display could be powered with six units. A 256-unit array demonstrated a phone-charging connection through a voltage-boosting circuit.

Future directions
The team says there are still challenges to overcome before widespread commercialization is possible. Device performance depends on water availability and environmental conditions, with higher humidity reducing voltage. Commercial costs, manufacturing scale and durability beyond the laboratory tests are still unresolved. Further development may require improving channel structure and surface chemistry to increase useful electrical output, since output is still low. Combining the generators with solar, wind or other water-energy harvesters may also help supply more reliable power.

Still, these devices may offer a good opportunity for supplying supplementary power in certain environments. The study authors write, “Benefiting from evaporation-driven electricity generation, LSG-WEGs could provide supplementary power for low-power sensors and wireless modules in environmental monitoring, such as agricultural IoTs, where continuous evaporation is available but battery replacement is difficult and costly.” https://techxplore.com/news/2026-11-lotus-stems-biofilms-generate-electricity.html

Alternative energy x 4